How to Install Lid Organisers
How to Install Lid Organisers
Lid organizers are a great way to utilize the otherwise unused space in the lid of the case. In most Protector cases they are attached by screwing into pre-moulded lid bosses, but in some older Protector cases and all Storm cases they are attached using nylon with an adhesive backing.
Install in cases with pre-moulded bosses
Step 1: Align Lid Organiser Holes with Lid Bosses
If yours needs to be screwed in, first align the holes in the lid organiser with the premoulded raised bosses in the case lid.
Step 2: Screw it in Place
Use a Phillips head screwdriver to carefully screw it in place.
If your case does not have the raised bosses, do not attempt to screw your organiser in, as this will void your warranty.
Install in cases using adhesive Velcro backing
Step 1: Clean Stacking Ribs on Inside of Lid
If using the Velcro adhesive backing, for the best attachment, first clean the stacking ribs on the inside of the lid and allow to dry.
Step 2: Stick Velcro Onto Stacking Ribs
Step 2: Stick Velcro Onto Stacking Ribs
Next, remove the release film from the Velcro hook material and carefully stick each strip onto the stacking ribs.
Step 3: Attach Lid Organiser to Velcro Strips
It is recommended to wait 24 hours before using so the adhesive will take full bond strength to the inside of the lid. Attach your lid organiser to the lid of the case using Velcro.
___
And that’s it. You have successfully attached your lid organiser to your Peli case.
Check out some of our other tutorials:
How to Set Up Peli Cases with Panel Frames
How to Set Up TrekPak™ Dividers
How to Set Up Peli Cases with Pick N Pluck Foam
How to change a latch on a Peli case
Check out our full case catalogue and our different interior case solutions
